by John Davidson | Mar 1, 2022 | Hoses, Proportioners & Reactors, Spray Guns, Transfer Pump
Avoid unnecessary down time by performing maintenance checks before you start your day. It is easier to perform these checks while the system is cool and pressure free. Taking this step saves you downtime later if something was wrong.
by SprayWorks Equipment | Feb 12, 2022 | Hoses, Material, Proportioners & Reactors
When using new material, always check the manufacturer’s SDS for recommendations on spraying. Every material sprays differently in different environments and by following recommendations provided, you will be able to spend less time making adjustments and...
by SprayWorks Equipment | Dec 12, 2021 | Documentation, Proportioners & Reactors, Weather
How often do you give your rig a good thorough cleaning? You should do a thorough cleaning and inspection a few times a year. Taking the time to clean your rig from top to bottom will help you see any regular wear and tear from use and be able to address those areas...
by Dave Penta | Dec 1, 2021 | Proportioners & Reactors
Perform Equipment Shutdown Procedures. Disconnect FTS cable at proportioner. Test with ohmmeter between pins of cable connector. If cable fails test, Repair Fluid Temperature Sensor (FTS)Disconnect FTS Cable Pins Result 1 to 2...
by Dave Penta | Jul 1, 2021 | Proportioners & Reactors, Transfer Pump
What you need to know before changing hydraulic oil is when operating in ambient temperature recommendations of 0 to 90°F (-17 to 32°C) frequency is about 1000 hours or 12 months, whichever comes first and/or in 90°F and above (32°C and above) 500 hours or 6 months,...
by John Davidson | Mar 1, 2018 | Material, Proportioners & Reactors
It’s less common when material will not spray on the ‘A’ side and ‘B’ side at the same time, but when it happens, there could be a number of factors at play. If you find yourself in this position, take a look at these common reasons;...
