by SprayWorks Equipment | Aug 28, 2025 | Tips from the Experts
Any other tech tips you want to add? Spray clean material, grease your threads on your A side bung adapters, y filters on your gun and do not soak your gun in...
by SprayWorks Equipment | Aug 21, 2025 | Tips from the Experts
What is the most common mistake when maintaining your hoses? Twisting it, running over it and missing the insulation on...
by SprayWorks Equipment | Aug 14, 2025 | Tips from the Experts
What is the most common mistake when maintaining your proportioner? Not changing your DOP. Basically a proportioner doesn’t need a whole lot of attention Make sure your DOP’s change pump loop or throat sealed...
by SprayWorks Equipment | Aug 7, 2025 | Tips from the Experts
What is the most common mistake when maintaining your gun? Not greasing up your rings while you’re putting it back together. You could chip your ring, it could cause leakage, putting the side seals in backwards if you have side seal screws and not greasing your...
by SprayWorks Equipment | Jul 31, 2025 | Tips from the Experts
What do you recommend for flushing your coating equipment? Flushing it out with latex paint? Use water, if you’re going to store it, put mineral spirits in it. And what do you recommend for your foam equipment? Flush it out with hydraulic fluid. The A side needs...
by SprayWorks Equipment | Jul 24, 2025 | Tips from the Experts
My favorite spray gun would be the Fusion PC. It’s easier and quicker to work on. Make sure you keep your filters in it because the cartridge is very sensitive, especially the A side. I really like the AP 2 gun, too. It’s got a good trigger on it. My most...
