Cleaning A/B Filters

Sometimes chemical cleaning the A and B filters can leave too much residue and plug up the screen hole. My suggestion? Re-new your filter screens.

You can do it with a few tricks. Try using a light amount of heat from a torch and burn out any restrictions. Once the restrictions are burned off, use air to blow out excess from the screens. Finally, hold your screen up to a light to ensure it is clear and ready to use again.

Service Hoses

It’s important to service hoses at least once per year. Periodic inspections assure the integrity of the protective wrap by repairing worn areas. Small, but mighty, the protective wrap is vital in protecting the hoses and electric lines. So, when hoses are rubbed or worn thin, bursting can happen. Also, when electric lines are exposed, shock hazards and hot spots are a real concern – resulting in poor heating performance and leading to failure, damages, and injury.

It seems tedious, but proper inspection and service of the hose requires removal of all protective coverings, inspection of each material, electrical and air line for slices or areas which have worn or the hose has pulled apart at the jacketing. If you see any corrosion in the fittings, a simple acid wash and wiping off excess areas with steel wool, will help. Make sure you wipe clean then apply a light film of rust inhibitive paint. Inspect all electrical connections and exposed wires, then repair as necessary to test for continuity. It’s vital to make sure connections are properly sealed from weather.

Lastly, perform a 15 minute working pressure test (confirm test pressures for specific hose) and then rewrap the hose accordingly. It seems like a lot of steps, but trust me, you’ll be glad you did it!