PMC Proportioner Technical Service Bulletin

The new Autonics controllers are a slightly different look for proportioners PMC built in 2023 and beyond. 
the Set Point will still be on the Right-hand side and the system temperature will be on the Left. You will still raise and lower the Set Points with arrows as before and, if you need to use the Manual Hose Heat function, you just push the MODE button and, you will see a H pop up then, using the up arrow increase the power percentage value as needed. 

Also to be noted is that the Part Numbers for the controllers will continue to stay the same: A&B PN#201154, Hose PN#201155

SprayWorks Equipment Group is a spray foam and polyurea company; supplying equipment, training, material, mobile rigs, and parts – and a distributor for PMC, Graco, and Gusmer equipment. With nearly 100 years of combined experience, SprayWorks has knowledge in commercial and residential buildings, bridges, and infrastructure. SprayWorks provides training and education for new contractors and equipment operators; open cell, closed cell, polyurea & coating applications for interior & exterior building envelope design, waterproofing, below grade, bridge deck, barge, secondary containment all types of roofs and structures.

Leave a Reply

Your email address will not be published. Required fields are marked *